TUBULAR AERATOR

Rubber membrane hose is made of silicone and EPDM rubber, which has the characteristics of heat resistance, ozone resistance, acid and alkali resistance and good chemical stability.

heat, ozone, acid and alkali resistance, good chemical stability and other characteristics, compared with the general rubber

Compared with general rubber membrane, it can greatly improve its service life.

01

The support body adopts hollow, water-filled form, which greatly reduces the aerator's buoyancy in the water.

The buoyancy of the aerator in the water is greatly reduced.

02

Aeration holes for a zigzag long holes, so that it has a good tension and instantaneous

closure, aeration can be released when the diameter of less than 2MM micro-bubbles.

In order to obtain a high oxygen utilization rate, the oxygen utilization rate of 28 ~ 35%.

03

The use of air-guide tanks, so that the aerator inside the rapid and uniform distribution of gas, so that the

Aeration membrane tube force uniformity, extend the life of the aeration membrane tube and release gas

Uniformity of the release of gas bubbles, improve the aeration effect; air guide groove is a narrow concave groove, the rubber membrane tube on its

Groove, the rubber membrane tube area is not open aeration holes, stop supplying gas, the rubber membrane is close to the guide groove.

When the air supply is stopped, the rubber membrane is tightly attached to the guide groove, thus preventing the occurrence of sewage backflow.